Article Id: 1085
Publish Level: Nothing

Solar Power/Off Grid Furnace Operating

Kits are available to allow a Classic Edge model outdoor wood furnace to operate with 24V DC power supplied to the furnace. This works well for 24V DC systems that are powered by solar or wind energy. The kits include a 24V Combustion Fan, a low-voltage replacement power supply and installation instructions. See information below for kit part number for your model of Classic Edge. See your dealer for information about ordering one of these kits.

Classic Edge HD 350, 550 or 750 - Kit p/n 2500398

Classic Edge HDX 360, 560 or 760 - Kit p/n 2500633 (note that this kit will NOT work for the Classic Edge HDX 960).

NOTE: Central Boiler furnaces are manufactured to be powered with 120VAC; therefore this kit will not be needed if your power system currently uses 120VAC power.

NOTE: Some people install Central Boiler furnaces in conjunction with solar hot water systems to provide water storage and additional heat as needed. A Central Boiler furnace can be connected using a plate exchanger and function as a heat storage tank for summer-time water heating. The furnace also qualifies for tax credit.

 
Keywords: 24V conversion kit, 24V operation, connecting to off-grid system, off grid, operate furnace off the grid, solar panels, solar tubes
If you need a response or assistance, please visit our Dealer Locator to contact a dealer.

Warning

These procedures should be performed by a qualified individual and in accordance with any and all federal, state/provincial and local codes and regulations. When performing work on an appliance, observe all precautions in the literature, tags and labels attached to the appliance and other safety precautions that may apply. When working with electricity and electrical components, failure to follow precautions could result in property damage, personal injury or death.

WARNING indicates the presence of a hazard which can cause severe personal injury or death to an operator or bystander, or substantial property damage if ignored.

Do not proceed without testing the power is disconnected. Make sure the power cannot be reconnected while working with electrical components.